K9K TURBO engine - supercharged, in-line, liquid-cooled, four-cylinder, with ONS valve timing

We remove the rear glass to repair the door or to replace the glass We prepare the car and disconnect the negative battery terminal

Disassembly of a partially synchronized gearbox Disassemble in the following order: Remove the side cover with the switch mechanism.

We replace brake hoses if they have mechanical defects - scuffs, cracks or breaks, as well as if brake fluid leaks through the hose

We remove the engine flywheel when overhauling the engine or to replace the crown. Preparing the car for the task. Disconnect the negative battery terminal.

The engine cooling system is liquid, closed type, with forced circulation of the liquid. The system consists of a cooling jacket in the cylinder block and cylinder head, a radiator with an electric...

We replace the cylinder head gasket if a leak is detected at the junction of the head with the block. We also replace the gasket when removing and installing the cylinder head

We remove the headlights and lights of the car for replacement or repair

We check the belt of auxiliary units at each technical inspection, as well as in the event of a malfunction associated with possible damage or low belt tension.

We replace the supports if they are worn out We prepare the car and install it on a viewing ditch or lift

We remove the ramp to check and replace the injectors, as well as to dismantle the intake pipe.

The drive cable for the mechanical drive of the throttle valve is replaced in case of a break or if the cable in the sheath is difficult to move

Fuel from the tank goes through the fuel line to the diaphragm pump. It is driven by a camshaft eccentric that acts on the pump drive lever

We remove the gearbox oil seals when oil leaks through their edges The front wheel drive seals can be replaced without removing the gearbox

We remove the radiator for replacement or for repair in specialized workshops The radiator is removed as an assembly with the condenser (air conditioning radiator)

The air conditioner compressor is a rather complex, high-tech unit. Some components of the pump part of the compressor are made using selective assembly.

We disassemble the door to replace its elements or to repair it

In the article, we will consider the removal of the axle shaft, the replacement and adjustment of the hub bearings, the removal of the rear axle