Disconnect the negative battery terminal
After disconnecting the power, wait at least 1 minute for the airbag initiator capacitor to discharge.
Removing the driver's airbag.
You will need T15 and T50 TORX keys and screwdrivers.
Move the steering wheel to the position shown in the figure.
Remove the airbag module mounting screw.
Move the airbag module aside by the length of the wires.
Pull back the connector retainer
Disconnect the connector from the airbag module Safety
Also disconnect the second connector
Removing the airbag module in Assembly with steering wheel cover
Removing the steering wheel
Removing the steering wheel cover Speakers
Removing the steering column switch holder
Holder The steering column switch assembly is made as a single unit with the contact ring and is a non-disassemblable element.
Caution:
When turning on the ignition for the first time after installing the airbag, you must be outside the vehicle.
Turn on the ignition switch by reaching under the steering column.
Removing the front passenger airbag
Disconnect the negative terminal and wait at least 60 seconds after disconnecting.
Remove the storage compartment Box
Pull back the airbag module connector retainer
Disconnecting the connector from the airbag module
Unscrew the screw securing the airbag module to the instrument panel reinforcement.
Remove the front passenger airbag module from under the instrument panel.
Install the front passenger airbag and all the removed parts in Reverse order.
Do not disassemble the airbag module. Do not expose to temperatures above 95˚ C.