Nissan Almera

This section describes the design, maintenance, and repair of the Nissan Almera. The car is equipped with a K4M gasoline engine. Removal, installation, disassembly, and assembly of various vehicle components and mechanisms are covered.

We remove the starter if a malfunction occurs when starting the engine, when the defect clearly indicates a malfunction of the starter.

One of the reasons for the absence or incomplete charging of the battery is a partial or complete failure of the generator.

In this case, you have to remove the generator and check and repair.

The drive cable for the mechanical drive of the throttle valve is replaced in case of a break or if the cable in the sheath is difficult to move

We remove the instrument panel when repairing the interior heater, when replacing the wiring harness and performing some body work.

The wheel (working) cylinder of the rear wheel brake mechanism is replaced when the braking efficiency of the wheel decreases due to jamming of the pistons in the cylinder or leakage of brake fluid through the cylinder seals

We remove the throttle assembly to replace the throttle position sensor or the assembly itself, as well as to remove the receiver.

  1. How to remove the thermostat and thermostat housing of a Nissan Almera car
  2. Removing the transmission Nissan Almera
  3. Removing the exhaust manifold of a Nissan Almera with a K4M engine