To remove the floor tunnel trim, you will need a T20 TORX wrench, screwdrivers, and side cutters.
Disconnect the negative battery terminal.
Remove the two screws securing the rear trim on the right and left.
Use a screwdriver to pry up the edges of the gearshift lever boot frame where its fasteners are located.
Removing the frame.
Using side cutters to cut the clamp securing the boot to the gearshift lever
Removing the gearshift lever boot
Use a screwdriver to pry off the parking brake adjuster cover.
Disconnect Wiring harnesses from switches
Removing the cover
Prying Use a screwdriver to remove the upper trim panel.
Move the upper trim panel of the floor tunnel upward by the length of the wiring harness.
Press the cigarette lighter connector lock.
Disconnect the connector from the cigarette lighter connector.
Remove the two front screws securing the floor tunnel trim.
Removing the trim.
Reinstalling the trim in reverse order.