We replace the parts of the anti-roll bar when they are worn out

Preparing the car for the task and hanging the front of the car

Replacing elements of the front suspension stabilizer Mazda 6

We apply penetrating liquid WD-40 or its equivalent to the nuts

Replacing elements of the front suspension stabilizer Mazda 6

We unscrew the nut securing the hinge to the front suspension strut support bracket, holding the hinge pin from turning, and remove the nut

Replacing elements of the front suspension stabilizer Mazda 6

Disconnect the upper stabilizer link pivot from the support bracket

Replacing Mazda 6 front suspension stabilizer elements

We also unscrew the nut securing the lower hinge pin to the stabilizer bar

Replacing elements of the front suspension stabilizer Mazda 6

Remove the anti-roll bar

To replace the stabilizer bar and its cushions, you need to remove the front suspension subframe

Front suspension stabilizer bar mounting: 1 - stabilizer bar; 2 - stabilizer bar cushion; 3 - bracket for attaching the stabilizer bar; 4 - stretcher

We unscrew the bolts securing the brackets 3 of the stabilizer bar to the subframe and remove the bar 1 complete with brackets and rubber pads 2

Hook with a screwdriver and remove the bracket 3 fastening the stabilizer bar 1

Unclench pillow 2 and remove it from bar 1

We also remove the second pillow

Install parts in reverse order

After replacing the stabilizer parts, we check and adjust the wheel alignment