Lanterns and lamps are replaced in case of malfunction.
Removing taillights and replacing bulbs
To change the lamps in the lantern on the wing, open the trunk lid
Using a screwdriver, we pry the pin of the piston for fastening the trunk upholstery
Remove the piston
Bending the edge of the trunk upholstery
With a head of 10, unscrew the two nuts securing the lamp
Pry off the lining with a screwdriver
And remove the lining of the lantern
Remove the lamp from the car body
Turning the brake light and parking light bulb holder counterclockwise, remove the bulb holder from the lamp housing
Pull out the lamp from the socket.
Install the new W21/5W lamp in reverse order
Replacing the turn signal bulb
By turning the turn signal lamp socket counterclockwise, we take out the socket with the lamp from the lamp body
By pressing the lamp and turning it counterclockwise, we remove the lamp from the socket.
Install the new PY21W direction indicator bulb in the reverse order.
By turning the reversing light bulb holder counterclockwise, remove the bulb holder from the lamp housing
Pull out the lamp from the socket.
Install the new W16W reversing light bulb in the reverse order.
To remove the lantern, remove all cartridges with lamps from the lantern body.
Setting the background ri on the hind wing in reverse order.
To replace the position light bulb in the lamp on the trunk lid, remove the trim of the trunk lid, for this:
Using a flathead screwdriver, pry off the retainer for attaching the trunk lid upholstery
Remove the piston
In the same way, we take out another nine clips of the upholstery of the trunk lid
Remove the upholstery of the trunk lid
Turning the lamp socket counterclockwise, remove the socket with the lamp from the lamp body
Pull out the lamp from the socket.
Install the new W5W side light bulb in reverse order.
To remove the lantern, unscrew the two nuts securing the lantern with a 10 head
Having prying with a screwdriver, we squeeze the lamp from the trunk lid, removing the two pins of the lamp from the plastic bushings on the cover, and remove the lamp
Install the lantern in reverse order.
Replacing the fog lamp bulb, removing the lamp
We remove the fog lamp when replacing the rear bumper and if the bulbs are burned out.
We install the car on a lift or a viewing ditch
From the bottom of the car, turning counterclockwise, remove the cartridge with the lamp from the lamp housing
Pull out the lamp from the socket.
Install the new W21W bulb in the reverse order.
To remove the fog lamp, remove the cartridge with the lamp from it.
With a 10 head, unscrew the two nuts
Remove the lamp from the rear bumper.
Install the fog lamp in reverse order.
Replacing license plate light bulbs, removing lights
Remove the license plate light sign for its replacement and when replacing the trunk lid.
Remove the upholstery of the trunk lid, as described above.
By turning the lamp socket counterclockwise, we remove the socket with the lamp from the lamp body
Pull out the lamp from the socket.
Install the new W5W lamp in reverse order.
To remove the license plate lights, with a head of 10, unscrew the four nuts securing the decorative lining of the trunk lid
Using a screwdriver, press the tabs of the lining retainer, and remove the retainer from the hole in the trunk lid
We also remove the retainer on the other side of the overlay and remove the decorative overlay
We take out the cartridges with lamps from the lanterns
Use a screwdriver to pry off the left lamp
Remove it from the opening of the trunk lid.
We also take out another lantern.
Install the lights in reverse order.
