The vehicles are equipped with:
– separate lower door lights (they light when the corresponding door or floor storage compartment is opened);
- – interior lights (front and rear) with a time delay;
- – luggage compartment lights; – individual lights above each sun visor.
Time delay operation
The interior lights come on upon command from the UCH:
- – when one of the side doors or the tailgate is opened;
- – when the body opening elements are unlocked by a command from the remote control (or via the hands-free function).
Depending on the situation, the interior lights are switched off by the UCH with a time delay.
Switching off without a time delay:
– when the body opening elements are locked by a command from the remote control (the opening elements are closed);
Switching off with a time delay:
- – after the last opening element is closed;
- – when unlocking Opening elements with the remote control;
- – when the ignition is turned on (gradually).
The UCH turns off the interior lights after a time delay of approximately 20 minutes.
Interior Light
Depending on the location of the interior light and the vehicle's trim level, the light may be equipped with:
- – one switch for the central light;
- – a switch for the central light and spotlights;
- – a switch for the central light and two spotlights.
Replacing the Interior Light
Disconnect the negative battery terminal
Prying off the ceiling light diffuser
Removing the diffuser
Press the combination ceiling light mounting latch.
Remove the ceiling light from the opening in the headlining. Length of connected wires
Press the wire connector lock
Disconnect the connector from the dome light
Install the combination dome light in reverse order.
Replacing the glove compartment light
Disconnect the negative battery terminal
Press the glove compartment light switch all the way down and pull the light out to the length of the connected wires.
Disconnect the wiring harness from the ceiling light.
Reinstall the parts in reverse order.
Mirror Lighting
General Information:
In addition to the mirrors, sun visors can be equipped with lights built into the roof lining.
Fig. Sun visor mirror switch Sun visor: 1 - switch, 2 - visor mount, 3 - mirror cover.
The switch is located on the sun visor mirror cover (Fig. 3).
Fig. Power supply for the mirror illumination light: 1 - visor, 2 - central mount, 3 - multimeter connection point
Current is supplied to the light through the central mount of the sun visor (Fig. 4).
The switch operation is checked with a multimeter.
Test algorithm:
- – mirror cover closed (switch open)
- – light does not light
- – resistance is infinity;
- – mirror cover open (switch closed)
- – light is on
- – resistance is zero.
Removing and installing the door sill light
Removal:
Cars Can be equipped with separate lights controlled by the UCH when the storage compartments under the floor on the driver or passenger side are opened.
Fig. Removing the door sill light: 1 - Light
Install the special tool (Cag. 1597) on the door sill light and remove the light (Fig. 5).
Installation:
Insert the connector into the door.
Reinstall the light by pressing it from the opposite side.