We replace the supports if they are worn out
We prepare the car and install it on a viewing ditch or lift
Remove the cotter pin from the bolt of the right engine mount
Using the keys 19 and 17, unscrew the support nut
Raise the right engine mount with a jack, resting it against the flanging of the oil pan
Remove the support
The support consists of a spacer, a socket, an upper cushion with a washer, a protective cap and a lower cushion with a washer
Install the new support in reverse order
In the same way, we replace the support on the left side of the engine
To replace the rear supports of the power plant, remove the floor lining, for this:
Move the parking brake lever to the frontmost position
With a head of 10, unscrew the eleven bolts securing the left side of the floor cladding
Remove the rubber seals of the parking brake levers and the gearshift lever from the lining flanging
Passing them into the holes
Remove the left side of the floor cladding
Remove the cotter pin from the support bolt
Using a 19 wrench, unscrew the nut while holding the support bolt with a 17 wrench
Remove the bottom cushion with the washer
Jack up one side of the base plate
Remove the top cushion with socket and washer
Install the support in reverse order.
In the same way, we replace the support on the other side