Removing and installing rear door trim Renault Arcana

Remove the door upholstery to access the door parts

Tools required:

• - a set of pullers for car upholstery;
• - thin screwdriver;
• - keys TORX T15, T30.

We prepare the car and disconnect the negative battery terminal

Use a thin screwdriver to pry off the screw cap from the top right corner

Remove the plug, opening access to the screw fastening the lining of the inner door lock handle

Using a TORX T30 wrench, unscrew the screw securing the inner handle

In the niche of the armrest, use a thin slotted screwdriver to pry off the plug and unscrew the screw securing the armrest pad

We unscrew the screw of the lower fastening of the lining

Using a plastic puller, we unhook the clips of the upholstery fastening caps

We pull and pull the upper part of the upholstery against the movement, releasing the upholstery hook from engagement with the inner door panel

We press the latches and take out the inner door handle from the lining

We press the latch and disconnect the holder of the tip of the door lock drive cable

Remove the inner handle of the door lock

Remove the rear door lining

Install the cladding in reverse order

Watch a short video on installing the cladding

When installing the cladding, we check the serviceability of the caps mounts. We replace defective caps