In the article, we will consider the replacement of instrument panel switches and signaling sensors
We discussed the replacement of ECM sensors in the article - Removing and checking the ECM sensors of a Hyundai Solaris car
Hazard switch replacement
Disconnect the negative battery terminal
Remove the central trim of the instrument panel
Remove six screws
We take out the frame assembly with switches
We press the fasteners for attaching the decorative trim to the frame
Remove the overlay
We press the latches securing the alarm switch
And remove the hazard switch
Replacing the headlight electrocorrector control
Disconnect the negative wire from the negative battery terminal
Remove the decorative trim of the mounting block
We remove the regulator block from the instrument panel socket by squeezing the latches and pressing on it from the inside with your fingers
Remove the block of regulators to the length of the connected wires
And, having pressed the latches, disconnect the wire blocks
We press the latches of the headlight electric corrector
Remove the regulator
Install the headlight electric corrector in reverse order
Replacing the reverse light switch
The switch is mounted on top of the gearbox, next to the shift mechanism
We press the latch and disconnect the wire block from the switch
Unscrew the reverse light switch from the hole in the gearbox housing
Remove the switch
Install the switch in reverse order. Before installation, apply sealant to the threaded part of the switch
Replacing the parking brake indicator switch
The switch is mounted on the parking brake lever bracket
Disconnect the negative battery terminal
Removing the lining of the floor tunnel
Disconnect the wire tip from the parking brake indicator switch
We unscrew the fastening screw and remove the signaling device switch from the parking brake lever bracket
Install the switch in reverse order
Replacing the brake light switch
The switch is mounted on the brake pedal bracket
Disconnect the negative battery cable
Disconnect the wire block from the switch
Squeeze the ears of the brake light switch bracket
Remove the bracket
Turn the brake light switch a quarter turn counterclockwise
And remove the switch
Install in reverse order
Replacing the clutch pedal start sensor
The sensor is mounted on the top of the clutch pedal bracket
Disconnect the negative battery terminal
We press the latches and disconnect the wire block from the clutch pedal start sensor
Loosen the locknuts (shown on the removed pedal)
Unscrew the lower mounting nut and remove the clutch pedal start sensor
Install the sensor in reverse order
After installing the sensor, adjust the clutch pedal stroke
Replacing the clutch pedal end travel sensor
We press the latch and disconnect the wire block from the clutch pedal end travel sensor
Disconnect the wire harness holder from the clutch pedal bracket (shown on the removed pedal)
Loosen the locknuts
Unscrew the lower mounting nut and remove the clutch pedal end travel sensor
Install the sensor in reverse order
Oil pressure sensor replacement
Disconnect the negative battery terminal
We press the latch and disconnect the block of wires from the oil pressure sensor
Unscrew the oil pressure sensor
Install the oil pressure sensor in reverse order