Requires 8 wrenches, TorxT-25, TorxE8 head, flat blade screwdriver

Disconnect the negative battery terminal

Как снять дроссельный узел Renault DusterКак снять дроссельный узел Renault Duster

Remove the air filter housing cover

Using a flat screwdriver, pry the tip of the tube for supplying fuel vapor to the throttle assembly

We remove the tip of the tube from the hole in the throttle body.

Как снять дроссельный узел Renault Duster

The connection is sealed with a rubber ring

On the K4M engine:

Как снять дроссельный узел Renault DusterКак снять дроссельный узел Renault Duster

Disconnect the end of the throttle cable from the lever

Disconnect the wiring harness from the throttle position sensor connector.

With a head of 8, unscrew the two bolts securing the throttle assembly to the receiver

Как снять дроссельный узел Renault DusterКак снять дроссельный узел Renault Duster

We remove the throttle assembly, overcoming the resistance of the sealing ring

Using a screwdriver, pry off the rubber ring and remove it from the groove of the nozzle of the assembly

Как снять дроссельный узел Renault DusterКак снять дроссельный узел Renault Duster

We also remove the rubber o-ring from the other branch pipe of the assembly

On the F4R engine:

Как снять дроссельный узел Renault DusterКак снять дроссельный узел Renault Duster

We press the locking element of the latch of the block of wires of the engine management system

Pry off the wire harness retainer with a flathead screwdriver.

Как снять дроссельный узел Renault DusterКак снять дроссельный узел Renault Duster

We disconnect the block from the connector of the throttle assembly control unit

Using the E-8 head with an extension, unscrew the screw of the right-hand fastening of the air filter housing to the cylinder head cover

Как снять дроссельный узел Renault DusterКак снять дроссельный узел Renault Duster

Loosen the left screw

We remove the screws from the holes in the air filter housing and cylinder head cover

Как снять дроссельный узел Renault DusterКак снять дроссельный узел Renault Duster

We shift the air filter housing from the nozzle of the assembly and place it between the bulkhead shield and the collector

With a head of 8, unscrew the bolt securing the receiver to the throttle assembly

Как снять дроссельный узел Renault DusterКак снять дроссельный узел Renault Duster

We unscrew the bolt of the right fastening of the throttle assembly to the cylinder head cover

Loosen left bolt

Как снять дроссельный узел Renault DusterКак снять дроссельный узел Renault Duster

We take out the nozzle of the throttle assembly from the hole of the receiver and remove the throttle assembly

If the O-rings are damaged:

Pry off the rubber ring with a screwdriver and remove it

To facilitate the connection of the throttle assembly with the receiver and the air filter housing, we apply a thin layer of silicone grease to the o-rings.

Before installing the air filter housing, we check the condition of the rubber bushing in the housing connection with the fitting of the cylinder head cover.

Как снять дроссельный узел Renault DusterКак снять дроссельный узел Renault Duster

If the sealing sleeve is damaged or has lost elasticity, replace it with a new one.

When putting on the air filter housing on the nozzle of the throttle assembly, it ensures the connection of the sleeve 1 of the housing with the fitting 2 of the cylinder head cover.