Hoses and tubes are replaced if damage is found, as well as hoses are replaced after 150 thousand km of mileage or five years of operation of the car

Four brake hoses are installed on the car

Replacement of hoses and tubes of the Mazda 6 brake systemReplacement of hoses and tubes of the Mazda 6 brake system

To replace the hose of the front brake mechanism, remove the front wheel

Unscrew the bolt fastening the brake hose holder to the amortstoyki bracket

Replacement of hoses and tubes of the Mazda brake system 6

Unscrew the nut of the brake tube attachment to the hose tip

To prevent the liquid from flowing out of the brake tube, we plug the hole with a protective cap from the air outlet valve

Replacement of hoses and tubes of the Mazda 6 brake systemReplacement of hoses and tubes of the Mazda 6 brake system

Unscrew the bolt fastening the brake hose holder to the body bracket

Unscrew the bolt-fitting for attaching the hose tip to the working cylinder of the brake mechanism and remove the brake hose

We install the hose in the reverse order

Replacement of hoses and tubes of the Mazda brake system 6

When installing the hose, pay attention to the serviceability of the copper sealing washers, it is advisable to replace these washers during assembly

We replace the second front hose in the same way

Replacement of rear wheel brake hoses

We remove the rear wheel from the side of the replaced hose

Replacement of hoses and tubes of the Mazda brake system 6

Unscrew the nut of the brake tube attachment to the hose and disconnect the tube

To prevent the liquid from flowing out of the brake tube, we plug the hole with a protective cap from the air outlet valve

Replacement of hoses and tubes of the Mazda 6 brake systemReplacement of hoses and tubes of the Mazda 6 brake system

We remove the locking bracket from the tip of the brake hose fixed in the bracket on the bottom of the body

Unscrew the bolt-fitting for attaching the lower hose tip to the working cylinder of the brake mechanism

Replacement of hoses and tubes of the Mazda 6 brake systemReplacement of hoses and tubes of the Mazda 6 brake system

Installing a new hose in reverse order

Pay attention to the copper washers, replace them during assembly

We replace the second rear hose in the same way

Replacement of brake tubes

The principle of replacing brake tubes is the same as when replacing tubes

Replacement of hoses and tubes of the Mazda 6 brake systemReplacement of hoses and tubes of the Mazda 6 brake system

To replace the tube from the ABS unit, unscrew the nut of the tube attachment to the unit

Unscrew the supply tube to the brake hose of the left front wheel

We remove the tube from the clamps and holders and remove it from the car

After replacing the tubes and hoses, we fill the system with brake fluid and pump the system