Hold the multifunction switch lever in the extreme position (in the forced first gear position) using a plastic clamp and a bolt screwed into the gearbox housing (Fig. 1)
Fig. 1. Holding the multi-function switch lever with a clamp and bolt
Unscrew bolt 1 (Fig. 2).
Fig. 2. Bolt for fastening the leaf spring lever: 1 – bolt; 2 – roller; 3 – sector
Install the leaf spring lever by inserting the roller into the recess of the sector corresponding to forced engagement of the first gear (Fig. 3).
Fig. 3. Adjustment of the leaf spring lever: 1 – sector; 2 – recess
Screw in the lever bracket mounting bolt without tightening it (Fig. 4).
Fig. 4. Lever bracket mounting bolt: 1 – bolt
Install the tool (Bvi1462) in place of bolt 1 (see Fig. 2).
Hold the lever and screw in the fixture until it stops.
Tighten the leaf spring arm bracket mounting bolt to the required torque (9 Nm).
Remove the tool (Bvi1462).
Install the lever mounting bolt.
Tighten the lever mounting bolt to the specified torque (8 Nm).
If the hydraulic distributor is replaced, reset the self-tuning parameters using the command: RZ005 “Reset self-tuning parameters” and reset the automatic transmission oil service life counter using a diagnostic tool by entering the command: CF074 “Record the date of oil change in the gearbox.”
After executing command RZ005, be sure to drive repeatedly up and down gears to memorize the new values and settings.
Tighten to the required torque:
- – cover mounting bolts (10 Nm);
- – battery (40 Nm);
- – amplifier mounting bolts (21 Nm).
Installation is carried out in the reverse order of removal.