We remove the heater, ventilation and air conditioning control unit to replace backlight lamps, repair and replace the unit itself
Remove the lining of the instrument panel console and the overlay of the instrument panel console.
Removing the radio (article - Removing the electronic components of a Renault Duster car)
Using a Torx T-20 wrench, unscrew the two screws securing the control unit
We push the block into the opening of the instrument panel, removing the two pins of the block from the holes in the instrument panel
And move the block holders from the ledges of the instrument panel
Displaying the block from the dashboard
To replace the unit backlight
Turn counterclockwise to remove the lamp
Install the new lamp in reverse order.
We also replace another block illumination lamp.
We press the lever lock with our finger and pry the rod with a screwdriver
Disconnect the rod end from the temperature control lever
Use a screwdriver to pry the shell of the thrust
Remove the thrust shell from the holder on the block
Use a screwdriver to press the latch of the rod end, press the second latch with your finger
We remove the thrust shell from the holder on the block, while simultaneously removing the thrust tip from the recirculation damper drive lever.
Push the lock of the wire block
Disconnect the block from the connector of the control unit
Squeezing the lever lock with your finger, disconnect the rod end from the control valve drive lever
Remove the thrust shell from the holder on the block
Remove the control unit.
Install the control unit in reverse order.