Nissan Almera

We remove the steering wheel to replace it, as well as when removing the steering column switches, steering column or instrument panel

We replace the working fluid in the hydraulic drive of the brake system in accordance with the maintenance schedule - every 30 thousand kilometers or after two years (whichever comes first).

We remove the front suspension arms for replacement or repair.

Damage on the lever can be:

• - deformation of the lever itself;
• - ball joint wear;

The need to remove the steering column occurs due to a malfunction of the column shaft bearings or intermediate shaft universal joints

The purpose and work of the IAC

The idle speed controller is an electric stepper motor

We dismantle the subframe if you need to remove the gearbox or the entire power unit, as well as when replacing and repairing the subframe.

Electrical equipment is made according to a single-wire circuit: the negative terminals of sources and consumers of electricity are connected to the "ground" - the body and the power unit of the car, which act as a second wire

We remove the ceiling lamps and lamps in case of their malfunction, we also remove the ceiling lamps when dismantling the panels and parts where they are installed

Usually, the fan is removed to replace the electric motor, impeller or when removing the radiator

The belt replacement period, regardless of its condition, is 60 thousand kilometers or four calendar years, whichever comes first

We remove the instrument panel when repairing the interior heater, when replacing the wiring harness and performing some body work.

The immobilizer coil is put on a piece of pipe (welded to the steering column pipe) in which the ignition switch is installed.

The reason for the decrease in oil pressure may be a malfunction of the oil pump

Most electrical circuits are protected by fuses

Remove the steering gear for replacement or repair

We install the car on a lift or a viewing ditch