In the article, we will consider the replacement of car switches and switches
Removing the central light switch
Disconnecting the battery
Loosen the screw on the switch handle with a screwdriver
Unscrew the handle counterclockwise
Using round-nose pliers, unscrew the slotted nut of the switch
Remove the switch from under the panel
Marking the order of connecting wires
We unscrew the screws securing the wire lugs to the switch terminals with a screwdriver
Install the switch in reverse order
Replacing the rear fog light switch
Disconnect the negative terminal from the battery
Press the switch on the back side and remove it from the panel
Write down the order of connecting the wires to the switch
Remove the wire ends from the switch terminals
We install and connect the wires, according to the record
Removing the brake light switch
Disconnect the battery with the ground switch
Under the instrument panel, remove the wire ends from the switch terminals
We press the brake pedal, unscrew and remove the plastic switch buffer
Loosen the locknut tightening with a wrench 19
Unscrew the switch, holding the adjusting nut with a 19 wrench
Remove the switch
Install the switch in reverse order
Using the adjusting nut, set the switch to such a position that when the brake pedal is released, its button is recessed to the buffer
We connect the wires in random order
Replacing the alarm switch and relay
Disconnecting the battery
On the right side, from under the instrument panel, disconnect the wire block from the alarm switch
Squeeze the latches on both sides of the switch body and push it out of the panel hole
Install the switch in reverse order
Remove the alarm relay
To remove the relay, disconnect the wire block from it
Using a Phillips screwdriver, unscrew the two screws securing the relay to the body
One screw also holds the end of the ground wire
Remove the relay
Install the relay in reverse order
Adjusting and replacing the sound signal
To adjust the sound of the signal, turn the adjusting screw with a screwdriver to achieve a clear and loud sound
If the adjustment fails to adjust the sound signal, then replace it
We unscrew the two bolts of the signal bar with a 12 key
Remove the signal and disconnect the wire ends
We unscrew the nut of the sound signal with a key 13
Setting the beep in reverse order