engines
The engine must be thoroughly washed and cleaned after removal from the vehicle.
We install the engine on a stand or stand.
To check the compression, it is recommended to use compression testers for gasoline engines such as G-324 from “Triscko” Taiwan or KA-6721K from “KT TOOLS” Taiwan
We remove the air intake elements during a major overhaul or in case of malfunctions.
The fuel supply system ensures the filtration of fuel and its uniform distribution across the engine cylinders in metered portions at strictly defined moments
Below are the catalog numbers of the original spare parts that are most in demand during maintenance and repair of the engine.
In this article we will tell you how to install the timing belt of the K9K engine correctly.
Rotate the crankshaft so that the pistons are below the carbon deposit zone above the piston ring travel zone.
We remove the fuel rail to replace and check the operation of the injectors and when performing troubleshooting work related to the operation of the fuel system.
Piston pins are installed with an interference fit in the upper heads of the connecting rods and rotate freely in the piston bosses, so heat the upper head of the connecting rod to a temperature of 250˚ C
After we have prepared the nodes and the parts for assembling the cylinder block, we proceed to the assembly.
The assembly of a connecting rod with a piston is discussed in the article - "Piston assembly" .
Displaying fault codes
To display fault codes, turn off the engine, turn the ignition switch to the “I” position and turn on the diagnostic mode with the diagnostic test switch.
