car Mazda 6

Also available:

We remove the rear suspension arms for replacement, as well as for replacing the silent blocks of the arms

Replacing the upper arm of the rear suspension

We install the car on a lift or a viewing ditch

Also available:

We remove the throttle assembly for flushing the damper, as well as for replacement

If the throttle valve does not fully close, then there may be an increased idle speed

Also available:

We remove the upper arm of the front suspension to replace silent blocks or to replace the entire arm when the ball joint is worn and the arm itself is deformed

Also available:

If the intake manifold is leaking, the engine starts to run unevenly (troit)

If tightening the intake manifold mount fails to eliminate the leakage, then the gasket must be replaced

Also available:

The contact group and the ignition switch are replaced in case of wear

We prepare the car and disconnect the negative battery terminal