car Mazda 6
The compressor is mounted on the engine block and is driven by a ribbed belt
In the article, we will consider methods for troubleshooting engine parts before assembly
After disassembling the engine, which was described in the previous article, thoroughly wash the engine parts with kerosene and blow with compressed air
Remove the front door upholstery to access the internal parts of the door
We prepare the car and disconnect the negative battery terminal
We remove the camshafts when repairing the cylinder head, when it is necessary to remove the camshafts
In the article, we will consider the removal of the oil pump, engine oil cooler
We remove the elements of the air conditioning system for replacement or repair
We remove the ceiling lamps for interior and trunk lighting for replacement, as well as when repairing body parts
The steering column switches of the Mazda 6 are included in the module and cannot be replaced individually. In the event of a switch failure, the entire switch module is replaced
We remove the lining of the car floor tunnel to remove the instrument panel, and if necessary
We prepare the car and disconnect the negative battery terminal
The air conditioner compressor is a very complex, high-tech device.
Some components of the pump part of the compressor are made to order.
We remove the engine for repair or replacement
It is recommended to remove the engine assembly with the gearbox forward, removing it from the engine compartment