Renault Sandero

This section describes the design, maintenance, and repair of the Sandero. The car is equipped with a K4M, K7J, and K7M gasoline engine. Removal, installation, disassembly, and assembly of various vehicle components and mechanisms are covered.

Check the level in an automatic transmission every 15,000 km of the car.

Oil change is provided every 60 thousand kilometers of the vehicle.

  1. How to remove the lining of the Renault Sandero floor tunnel
  2. Replacement of elements of the ignition system of the Renault Sandero car
  3. How to replace the crankshaft seals Renault Sandero

Articles

We remove the heater elements for replacement or for repair. The removal and installation of the control unit were examined in the article – Removal of the heater control unit Renault Duster .

In the article, we will consider the complete disassembly of the front door and its removal

We remove the belt due to wear or when repairing engine systems We perform work on a lift or on a viewing ditch

We remove the tailgate for replacement, as well as for repair Removing tailgate upholstery

Checking the oil level in the automatic transmission Before checking the oil level, you need to drive the car so that the oil in the gearbox warms up to an operating temperature of 70-80 ° C

The instrument cluster is equipped with an audible signal to additionally inform the driver about critical and emergency modes of operation of the main vehicle systems.