We replace the transmission control cables if they are worn out
Remove the battery
Remove the battery shelf as described in the article - How to remove Hyundai Solaris manual transmission
We pry off the cotter pin of the cable end with a screwdriver
Remove the cotter pin from the hole of the axle of the gear lever
Remove the washer
Remove the tip of the cable from the axis of the gear lever
Remove the cotter pin of the cable tip from the hole in the axle of the gear selector lever
Remove the tip of the cable from the axis of the gear lever
Remove the ends of the cable sheaths from the socket of the bracket on the gearbox
Removing the lining of the floor tunnel
Raise the decorative cover of the gear lever
Pry off with a screwdriver
Remove the cotter pin from the gear lever pin hole on the right side
Remove the tip of the shift cable from the lever pin
Press the plastic retainer with your finger
We take out the tip of the sheath of the gear shift cable from the groove in the body of the backstage of the control lever
Press the ends of the spring clip with a screwdriver
Disconnect the end of the cable from the hinge of the gear lever
Press the plastic retainer with your finger
We remove the tip of the sheath of the gear selection cable from the groove in the backstage body
In the car, under the instrument panel, unscrew the two bolts that secure the cable bracket to the front of the car
We take out the cables into the cabin, taking out their tips one by one through the hole in the front shield
Install the manual transmission control cables and all removed parts in reverse order
Adjusting the manual transmission control actuator
If the gearshift is not clear, then the drive is adjusted by moving the adjusting bracket of the gearshift cable tip
Remove the tip of the shift cable from the lever pin
We move the adjusting bracket relative to the tip of the cable forward in the direction of the car, if I, III and V gears are not clearly included, and back - if the second and fourth gears are not clearly included
Install all removed parts in reverse order
Removing and installing gear lever backstage
Removing the lining of the floor tunnel
Raise the decorative cover of the gear lever
Disconnect the selector and shift cables from the control lever backstage
We press the clamps of the wire harness holder with screwdrivers and remove the wire harness holder from the hole in the case
We unscrew the four bolts securing the body to the base of the body
Removing the backstage
Install the gearshift linkage and all removed parts in reverse order
If the gear lever is difficult to move or there is a squeak when shifting gears, you can try to lubricate the lever hinge with grease without removing the rocker from the car. Perhaps, after lubricating the hinge, further disassembly of the backstage is not required.
