Select your language
The thickness of the brake disc must be at least 19.8 mm. If there are cracks, deep scratches, ripples, or other damage on the brake disc, it must be replaced.
The system of gas turbine supercharging and charge air cooling, by using part of the energy of the exhaust gases, provides the supply of pre-compressed and cooled air to the engine cylinders
We remove the basket and the clutch disc for replacement if they fail, as well as when replacing the flywheel and the rear crankshaft oil seal
The engine cylinder block is cast from cast iron The casting is subjected to artificial aging to relieve thermal stress, which allows the block to retain the correct geometric shapes and dimensions...
The diagnostic connector is located on the fuse and relay mounting block in the passenger compartment
We replace the fluid in the hydraulic brake and clutch drives every 90 thousand kilometers or after three years.
We replace the intake pipe gasket when repairing the engine, as well as when the gasket is worn, when tightening the bolts fails to eliminate air leakage
Disassembling the DPO (AL4) Automatic Transmission Input Shaft We discussed disassembling the DPO (AL4) automatic transmission in the article "Disassembling the Automatic Transmission."
In the article, we will consider the replacement of pads, brake drums, working cylinders, brake discs of the rear brake mechanism
