We install the cylinder head after repair, inspection and fault detection.

Before installing the cylinder head, set the cylinder pistons to the middle of the stroke.

  1. Removing the ECU and sensors COURT car Renault Duster
  2. Checking and replacing the accessory drive belt Renault Sandero
  3. Removal and installation of the timing belt of the K4M engine
  4. Nissan Almera Body Front Wiring Diagram
  5. How to remove the Renault Duster dashboard
  6. Design features of the K4M engine
  7. Cummins ISF2.8 Timing Chain Replacement
  8. Assembly of the engine block G4KD and G4KE Kia Magentis
  9. Replacing the accessory belt Nissan Almera
  10. Checking and replacing the timing belt of the Renault Sandero car
  11. Renault Duster engine cooling system design
  12. Renault Duster accessory belt check and replacement
  13. Checking and replacing the timing belt of the Renault Duster car

Proper selection and installation of the piston group plays an important role in engine operation All parts of the connecting rod and piston group are divided into categories and are selected...

We disassemble the door to replace its elements or to repair it

Preparing the car for work. Disconnect the negative battery terminal. Removing the transmission

Removing the cylinder head was discussed in the article - Removing the cylinder head We install the head on the workbench and disassemble the cylinder head.

We remove the fenders and bumpers of the car for replacement or for repair, as well as for approaching other elements of the car's structure

Clutch with manual transmission - dry, single plate, diaphragm

Remove the cylinder head to replace the cylinder head gasket.

We remove the main and working cylinder for replacement or for installing a cylinder repair kit

Disassembling the transfer case to replace worn parts We install the car on a viewing ditch or lift