Adjustment of thermal gaps in the valve drive is required for engines K7J and K7M.
For the K4M engine, valve clearance adjustment is not required, this engine is equipped with hydraulic valve clearance compensators
Select your language
Cooling system — liquid, closed type, with forced circulation
The power supply system consists of two fuel tanks, fuel lines, a switching valve, a fuel pump, a sediment filter, a fine fuel filter, a carburetor with a throttle and air damper drive, an air filter
The system of gas turbine supercharging and charge air cooling, by using part of the energy of the exhaust gases, provides the supply of pre-compressed and cooled air to the engine cylinders
We are preparing the car to complete the task. Disconnect the negative terminal of the battery Tools needed for the job: a piston puller, screwdrivers, a TORX T25 key, a 10 socket.
We replace the pads in the event of the maximum permissible wear of their pads or the rear wheel brake drum
An LG 08L5 alternator is installed on the car The conversion of electric current into direct current is carried out by the rectifier unit
Checking and adjusting the valve clearance must be done on a cold engine (coolant temperature 20˚С), with the cylinder head mounted on the block
We remove the rear suspension knuckle for replacement, as well as for replacing silent blocks
The rear suspension of the car differs in design, depending on the model In the article, we will consider the rear suspension of a 2WD and 4WD car.