Removing and refitting the GAZelle Next electronic control unit

We remove the electronic unit for checking or for replacement.

We prepare the vehicle for the work.

The following are required: 10 mm and 13 mm spanners and a screwdriver. The engine control unit (ECU) is mounted in the engine compartment on a bracket; the housing is aluminium, the connectors have sealing rings, and the fixings are M6 nuts (10 mm spanner) and M8 nuts (13 mm spanner).

We open the bonnet, switch off the ignition and remove the battery.

ECU in the engine compartment on its bracket
We remove the battery and gain access to the ECU

We undo the two upper nuts securing the unit, which at the same time secure the blade-fuse block bracket.

Two upper nuts on the unit bracket
We undo the two upper nuts securing the unit

We move the bracket aside.

Bracket moved aside
We move the bracket aside

We press in the catch.

Plastic catch on the connector
We press in the catch

We flip up the retaining clip of the upper wiring harness connector.

Retaining clip of the upper connector
We flip up the retaining clip of the upper wiring harness connector

We disconnect the upper wiring harness connector from the ECU.

Upper harness connector disconnected
We disconnect the upper wiring harness connector from the ECU

We also disconnect the lower wiring harness connector from the unit.

Lower wiring harness connector
We also disconnect the lower wiring harness connector from the unit

We undo the two lower mounting nuts and remove the unit.

Two lower mounting nuts of the unit
We undo the two lower mounting nuts and remove the unit

We refit the control unit in the reverse order.

ECU refitted in place
We refit the control unit in the reverse order

If there is moisture on the connectors, it must be removed with a fast-drying contact cleaner.

The tightening torque of the unit mounting bolts is 18 N·m.

We refit the battery.