car Mazda 6

Mazda 6The Mazda 6 has various optional equipment depending on the trim level.

This vehicle is equipped with L8, LF, L3, and L3 Turbo engines.

Gasoline engines: 16-valve DOHC

Diesel engines: 16-valve DOHC

Assembling the engine after preparing and inspecting parts for assembly

Blow compressed air through the cooling channels, lubrication channels, cylinders and crankcase

It is recommended to change the brake fluid after 30 km or two years of operation

The brake hydraulic drive must be pumped to remove air that got there when changing the fluid or after replacing the hydraulic drive components

Manual transmission vehicles are equipped with a single plate diaphragm clutch

Pressure plate in a stamped steel casing, attached with six bolts to the engine flywheel

  1. Removal and installation of elements of the Mazda 6 engine oil system
  2. How to remove and install the fuel tank of a Mazda 6 car
  3. The design of the rear suspension of the Mazda 6 car

Removing the rear door trim for repair or replacement of rear door components and its repair.

We remove the oil separator to clean it from deposits, as well as when dismantling the cylinder...

We discussed the removal and disassembly of the UMP engine in previous articles In this article,...

At every maintenance, the condition of the brakes should be checked.