car Mazda 6
It is recommended to change the brake fluid after 30 km or two years of operation
The brake hydraulic drive must be pumped to remove air that got there when changing the fluid or after replacing the hydraulic drive components
We replace the elements of the engine exhaust system in case of damage or burnout
In this article, we will look at how to remove the wiper elements and replace them
Most of the vehicle's electrical power circuits are protected by fuses
Headlights, fan motors, fuel pump and other powerful current consumers are connected via relay
We replace hoses and tubes if damage is found, and we also replace hoses after 150 thousand kilometers or five years of vehicle operation
The car has four brake hoses
In the article, we will consider how to replace the lamps of the headlight, direction indicators, ceiling lamps and lanterns
Before replacing the lamps, you must disconnect the negative terminal of the battery
Replacing the engine oil pressure drop sensor
The emergency pressure drop sensor is installed in the cylinder block in the left front of the engine (above the oil filter)
When valve stem seals are worn, there is increased oil consumption and oily spark plug electrodes
We replace the shock absorber and spring of the rear suspension in case of deformation or breakage
In the article, we will consider the replacement of the coolant temperature sensor, the DMRV sensor and the absolute pressure and air temperature sensor in the intake manifold
The caliper and disc are replaceable in case of wear or breakage
Preparing the car for the task
