Renault Sandero

This section describes the design, maintenance, and repair of the Sandero. The car is equipped with a K4M, K7J, and K7M gasoline engine. Removal, installation, disassembly, and assembly of various vehicle components and mechanisms are covered.

Remove the fuel rail and injectors for inspection and replacement.

  1. Removing and repairing the Renault Sandero starter
  2. Replacing parts and assemblies of the front suspension Renault Sandero
  3. How to check and adjust Renault Sandero engine valves

Articles

Inspection and fault detection of the connecting rod and piston group is discussed in the article - " Repair of the connecting rod piston group ”.

We replace pads in case of maximum permissible wear of their pads - the minimum thickness of the pad, including its base, must be at least 6 mm

We remove the protection and mudguards of the engine to gain access to the components and parts of the power unit.

We remove the rear glass to repair the door or to replace the glass We prepare the car and disconnect the negative battery terminal

The steering of a car with a hydraulic booster and a rack-and-pinion steering mechanism.

In the article, we will look at how to bleed the refrigerant from the system, replace the tube seal rings and parts, and replace the cabin air filter element