To overhaul the engine, we disassemble the cylinder block.

  1. Design features of the ZMZ-402 engine
  2. How to check and adjust Renault Sandero engine valves
  3. How to replace fuses in a Renault Duster car
  4. Checking and replacing the engine coolant Renault Duster
  5. Fuses and relay Renault Sandero
  6. Installing the cylinder head of the K4M engine
  7. Removing the ECU and sensors COURT car Renault Duster
  8. Checking and replacing the accessory drive belt Renault Sandero
  9. Removal and installation of the timing belt of the K4M engine
  10. Nissan Almera Body Front Wiring Diagram
  11. How to remove the Renault Duster dashboard
  12. Design features of the K4M engine
  13. Cummins ISF2.8 Timing Chain Replacement
  14. Assembly of the engine block G4KD and G4KE Kia Magentis
  15. Replacing the accessory belt Nissan Almera

We remove the power steering pump when dismantling the engine or to replace it

The TDC setting is needed when replacing the timing belt and for other repairs on the engine

We remove the cylinder head to replace the gasket under the head or to repair the cylinder head itself.

The purpose and work of the IAC The idle speed controller is an electric stepper motor

For cars with manual transmissions, a dry single-plate clutch with a central diaphragm spring is installed

To prevent damage to the paintwork of the body wings, it is necessary to use a special coating

We remove the oil separator to clean it from deposits, as well as when dismantling the cylinder head cover

High voltage ignition coils mounted directly on the spark plugs

The factory recommends replacing the filter element after 45,000 km, but this depends on the operating conditions