The system of gas turbine supercharging and charge air cooling, by using part of the energy of the exhaust gases, provides the supply of pre-compressed and cooled air to the engine cylinders

We remove the steering wheel of the car when dismantling the steering column and removing the instrument panel.

We remove the front door upholstery to repair and replace door elements, as well as when repairing door panels or replacing the door itself.

The steering mechanism is removed for replacement or repair, to replace steering rods or damaged protective covers.

Checking and topping up the coolant should be done on a cold engine. It is necessary to add coolant of the same brand as it was filled in.

Before removing any components of the fuel injection control system, disconnect the wire from the negative terminal of the battery

A condenser (air conditioning radiator) of a multi-flow type is installed in front of the radiator of the engine cooling system

In the article, we will consider the removal of the brake drum, the replacement of the pads and the replacement of the brake slave cylinder.

The rear window heating element consists of horizontal conductive strips connected on both sides by vertical busbars

We remove the window lifter for replacement, as well as for repair We prepare the car and raise the glass to the upper position

If the crankshaft position sensor fails, the engine cannot be started. If the camshaft sensor fails, the engine will run unstable, there will be high fuel consumption

Remove the fuel rail to access other parts and assemblies, as well as to replace the injectors Preparing the car for the task

We remove the seats for repair, as well as for approaching the details and components of the car inside the cabin

We remove the car engine together with the gearbox, lowering it down from the engine compartment

The car has three independent braking systems: service, spare and parking. The service brake system is hydraulic, dual-circuit (divided into front and rear circuits), with a vacuum booster, pressure...

The main dimensions of the crankshaft are given in Figure 1. Crankshaft - cast, cast iron, five-bearing. It is possible to regrind the crankshaft journals during repairs with a diameter reduction of...

In this article, we will look at how to disassemble and remove the car cab door. Preparing the car for the task. Disconnect the negative battery terminal.

In the article, we will consider the replacement of individual parts of the tailgate and disassembly of the door