Replacing the front wheel brake cylinders and pipes

We prepare the vehicle for repair and drain the brake fluid from the system, as described in previous articles. We partially remove the brake shoes to provide access to the cylinders.

Dismantling the brake hose and pipes

Removing the upper and lower brake cylinders

We temporarily refit the brake shoe pivot pins and tighten their nuts so that the shoes do not obstruct the work.

Assembly and adjustment

We install the lower wheel brake cylinder together with the brake shoe into the hole in the brake backplate and secure them with the shoe support pin.

We screw the union bolt with the T-piece into the cylinder, using two new copper washers installed on both sides of the T-piece. Then, we screw the brake pipe union into the T-piece.

We install the upper wheel brake cylinder with the brake shoe and its support pin. We screw the extension with the T-piece, pipe, and new copper washers into the cylinder.

We tighten the nuts of the brake shoe support pins, preventing them from turning. We tighten the union bolt of the lower cylinder, the adapter of the upper cylinder, and the union of the brake pipe of the lower T-piece.

We finally mount the brake shoes onto the brake backplate and press them with the pins, springs, and cups. We install the return springs.

By turning the eccentric bolts, we bring the brake shoes closer together. We install the brake drum and adjust the clearance between it and the brake shoes.

Finally, we bleed the brake system to remove air, as described in previous articles.