We remove the protection and mudguards of the engine to gain access to the components and parts of the power unit.
Protection and mud flaps serve to protect against damage and protect against contamination of the elements of the power plant.
The right and left mud flaps consist of an upper part and a lower part.
To complete the task, you will need a Torx T-20 wrench, a set of screwdrivers and a 10 wrench.
We install the car on a lift or a viewing ditch.
We unscrew the three screws of the front fastening of the lower part of the mudguard.
The front bumper is fixed at the same time with the same bolts.
Unscrew the retainer of the rear mount
Removing the piston
Pry off the large fastening clip with a screwdriver
And remove the large piston for fastening the lower part of the right mudguard
It is good to remove the caps with a special puller
Remove the latches of the lower part of the mudguard from engagement with the upper part of the mudguard and the front bumper
Remove the lower part of the mudguard
Pry off the piston with a screwdriver or puller
And remove the piston of its lower mount
We unscrew the plastic nut of the upper attachment to the body
Remove the upper part of the mudguard
Install the mudguard in reverse order
Remove engine protection
To remove the crankcase protection, unscrew the six mounting bolts
And remove the protection
Install protection in reverse order.