UAZ car

We prepare the car and drain the brake fluid, as indicated in previous articles

Remove the brake pads

Remove the brake hose, for this

The driveline consists of front and rear shafts that transmit torque from the transfer case to the drive axles.

Each cardan shaft has needle bearing universal joints at the ends

We prepare the car and remove the rear wheel from the side of the task being performed

Remove the brake pads from the brake shield and leave them hanging on the support pins

Usually, the manifold is removed to replace the gaskets, as well as when repairing the cylinder head and engine

We remove the belt due to wear or when repairing engine systems

We perform work on a lift or on a viewing ditch

In the article, we will consider the removal of tailgate parts

Replacing tailgate stops

In the article, we will consider the design features of the engine cooling system and the replacement of the coolant of a UAZ car

The thermostat is replaced in case of overheating or insufficient warming up of the engine coolant, when the defect clearly indicates incorrect operation of the thermostat

We prepare the car for the task, install it on a horizontal platform and remove the wheel from the side of the work being done

Removing the steering gear for replacement or repair

We install the car on a viewing ditch or lift