The driveline consists of front and rear shafts that transmit torque from the transfer case to the drive axles.
Each cardan shaft has needle bearing universal joints at the ends
Remove the pump for repair or replacement
Remove the pump drive belt
We prepare the car and disconnect the negative battery terminal
We prepare the car for the task and install it on a lift or a viewing ditch
Remove the gearbox
We remove the rocker arm axis when removing and repairing the cylinder head
Remove the cylinder head cover, as indicated in the article "How to adjust engine valve clearances"
Preparing the car for the task
Remove the front wheel from the side of the work being done
We reduce the brake pads
Adjustment of the regulator is necessary after replacing the rear springs or the rear axle, as well as during the operation of the car
