UAZ car
We remove the gearbox for repair, as well as when replacing clutch discs and when removing the engine
The car is equipped with a dry, single-disc, permanently engaged clutch with a hydraulically actuated release mechanism
Disassembling the gearbox to replace worn parts
We show the disassembly using the example of a four-speed gearbox with synchronizers in III-IV gears
In the article, we will consider the design features of the engine cooling system and the replacement of the coolant of a UAZ car
We check and adjust the valve clearances when repairing the cylinder head, as well as when a characteristic engine knock appears in the upper part of the cylinder head
UAZ vehicles are equipped with two types of rear axles - with a single final drive or with additional wheel reduction gears
The ignition system is non-contact.
It consists of a distribution sensor, a switch, an ignition coil, spark plugs, additional resistance, an emergency vibrator, high and low voltage wires
In the article, we will consider disassembling the cardan shaft and replacing the crosspieces
We install the car on a viewing ditch or lift and remove the driveline, as described in the previous article
The clutch drive is adjustable if a spring-lever clutch is installed on the car
We install the car on a viewing ditch or lift
Disconnect the negative battery terminal
Disassembling the carburetor to clean and replace worn parts