Replacing the clutch discs is necessary when the force on the pedals decreases when the clutch is released (and, accordingly, the stroke increases), which indicates a large wear on the surface of the drive disc or "draft" of the spring
We replace the rear wheel pads in case of damage, oiling and wear of the pads to a thickness of less than 1 mm.
A liquid-type heater is installed on the car
The sensors of the engine control system during engine operation and when the engine is started constantly monitor and maintain the set parameters and transmit signals to the electronic control unit
When replacing the high/low beam lamp, do not touch the lamp bulb with your fingers, because due to the high temperature of the bulb, any surface contaminants (for example, fingerprints) burn out during operation, leaving blackening
The cardan gear consists of an intermediate cardan shaft, an intermediate support, a rear cardan shaft and three cardan joints.
If, when pressed, the clutch pedal reaches the stop without resistance
The clutch does not disengage
