We remove the suspension assembly for replacement or overhaul

To complete the task, you will need tools: wrenches for 13.16, 19, 22, 24, a head for 17, a jack, a ball joint remover, a spring compressor.

Replacing the clutch discs is necessary when the force on the pedals decreases when the clutch is released (and, accordingly, the stroke increases), which indicates a large wear on the surface of the drive disc or "draft" of the spring

We replace the rear wheel pads in case of damage, oiling and wear of the pads to a thickness of less than 1 mm.

A liquid-type heater is installed on the car

The sensors of the engine control system during engine operation and when the engine is started constantly monitor and maintain the set parameters and transmit signals to the electronic control unit

When replacing the high/low beam lamp, do not touch the lamp bulb with your fingers, because due to the high temperature of the bulb, any surface contaminants (for example, fingerprints) burn out during operation, leaving blackening