UAZ car
Usually, the manifold is removed to replace the gaskets, as well as when repairing the cylinder head and engine
A dependent front suspension of two types is installed on cars: spring or spring-lever
We prepare the car and remove the engine, as indicated in the previous article
Flushing the outside of the engine
In the article, we will look at how to remove the fuel tank and fuel tank elements
We remove the cylinder head to replace the gasket between the head and the cylinder block, as well as for repair
We discussed the removal and disassembly of the UMP engine in previous articles
In this article, we will consider the stages of assembling the UMP engine
We prepare the car and drain the brake fluid from the system
The ignition system is non-contact.
It consists of a distribution sensor, a switch, an ignition coil, spark plugs, additional resistance, an emergency vibrator, high and low voltage wires
The car can be equipped with a starter 42.3708 or 4211.3708-01 or 62.3708
Starters have almost the same design
We prepare the car for the task, install it on a horizontal platform and remove the wheel from the side of the work being done
We remove the main and working cylinder for replacement or for installing a cylinder repair kit