UAZ car
Serving the fuel pump while replacing fuel filter elements
Remove and disassemble the pump for repair
The frame consists of two box-shaped spars of variable section, interconnected by five crossbars
In the article, we will consider disassembling the cardan shaft and replacing the crosspieces
We install the car on a viewing ditch or lift and remove the driveline, as described in the previous article
We remove the main and working cylinder for replacement or for installing a cylinder repair kit
We prepare the car for the task and install it on a lift or a viewing ditch
Remove the gearbox
The ignition system is non-contact.
It consists of a distribution sensor, a switch, an ignition coil, spark plugs, additional resistance, an emergency vibrator, high and low voltage wires
UMP-4178, -4179, -4218 or ZMZ-4021, -4104 engines are installed on the car.
They all have basically the same design
The power supply system consists of two fuel tanks, fuel lines, a switching valve, a fuel pump, a sediment filter, a fine fuel filter, a carburetor with a throttle and air damper drive, an air filter
We prepare the car and remove the rear wheel from the side of the work performed
We reduce the brake pads of the wheel
Transfer box - two-stage, without center differential, with neutral gear and front axle disengagement
The electrical equipment of the car is made according to a single-wire circuit: the negative terminals of sources and consumers of electricity are connected to the body and other units of the car, which act as a second wire
