• Home
    • Safety
  • Separator
    • Mazda 6
    • Nissan Almera
    • Renault Sandero
    • Renault Arkana
  • Separator6
    • Duster
    • GAZELLE NEXT
    • Solaris
    • UAZ car
  • Separator-2
  • Engines
  • Separator-3
  • transmission
  • separator-4
  • Search

Select your language

  • Русский
  • Українська (Україна)
  • Қазақша (kk-KZ)
  • English (UK)
  • Español (España)

How to disassemble and assemble the fuel module of the Mazda 6 car

Disassembling the fuel module to replace the elements of the fuel module

Removing the fuel module is described in the previous article

Replacement and refilling of oil in the Mazda 6 manual transmission

It is necessary to check the oil level in the gearbox after 15,000 km of the car's run, and after 75,000 km of run it is necessary to change the oil

Checking and adjusting the camber of the wheels of the Mazda 6 car

To ensure good vehicle stability and handling, as well as uniform tire wear during operation, it is necessary to check and adjust the wheel alignment

How to disassemble the engine of a Mazda 6 car

Disassembling the engine to replace worn parts

It is advisable to disassemble the engine on a special turntable

The design of the exhaust system Mazda 6

Exhaust gases exit the engine through the exhaust manifold, downpipe, catalytic converter, resonator and main mufflers

Removing the upholstery of the rear door of the car Mazda 6

Remove the door trim to access the internal parts of the door

We prepare the car and disconnect the negative battery terminal

How to remove and install the amort front suspension rack Mazda 6

We remove the shock absorber strut of the front suspension to replace the elements of the strut or for repair

We install the car on a lift or hang the front of the car on a jack and substitute reliable stops

Page 4 of 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10