Renault Sandero

This section describes the design, maintenance, and repair of the Sandero. The car is equipped with a K4M, K7J, and K7M gasoline engine. Removal, installation, disassembly, and assembly of various vehicle components and mechanisms are covered.

We replace the fluid in the hydraulic brake and clutch drives every 90 thousand kilometers or after three years.

  1. Checking and replacing the accessory drive belt Renault Sandero
  2. Removal and repair of the Renault Sandero generator
  3. Renault Sandero engine pan gasket replacement

Articles

The car starter is a four-pole four-brush DC motor with permanent magnet excitation, combined with a freewheel and an electromagnetic two-winding traction relay

We remove the engine flywheel when replacing the engine crankshaft oil seal, as well as for repair or replacement.

We remove the bumpers to access other parts and assemblies of the car, as well as when replacing or repairing bumpers.

These vehicles are equipped with: – a system for automatically adjusting each headlight depending on changes in body height, acceleration, braking, and vehicle speed;

Most of the vehicle's electrical power circuits are protected by fuses Headlights, fan motors, fuel pump and other powerful current consumers are connected via relay

The fuel system uses electro-hydraulic injectors, the operation of which is controlled by an electronic control module