In the article, we will consider possible malfunctions that may occur during the operation of the car.

  1. Assembling the H4M engine
  2. Running and stopping the engine of the car Renault Arkana
  3. Disassembly of the cylinder block of the K4M engine
  4. Design features of the ZMZ-402 engine
  5. How to check and adjust Renault Sandero engine valves

We remove the rear wheel drives when dismantling the rear gearbox, when replacing the drives themselves, replacing the mudguards of the internal and external hinges

Remove the subframe for access to other suspension elements and for repair We install the car on a lift or a viewing ditch

Two compression rings and one oil scraper are installed on the piston. Compression rings are designed to prevent gases from escaping into the crankcase when they are compressed and expanded

The oil pump housing is a single casting with the front cover of the cylinder block If the pump needs to be replaced, the cover is replaced as an assembly.

We replace the pump in case of noise from its bearing or in case of tight rotation of the pump pulley, large radial play of the pump shaft

We are replacing the camshaft due to wear of the journals and cams of the camshaft. If the camshaft journals are heavily worn, there will be low pressure in the engine lubrication system.

Usually the heater is removed to replace the evaporator or to repair the heater.

The car accelerates poorly There are many reasons for the deterioration of dynamics, the main ones can be defined as follows.

The clutch drive is adjustable if a spring-lever clutch is installed on the car