Remove the anti-roll bar to replace the stabilizer parts
We install the car on a lift or a viewing ditch
The contact group and the ignition switch are replaced in case of wear
We prepare the car and disconnect the negative battery terminal
We remove the glass and window regulator of the door for door repair, as well as for replacement
We remove the upholstery of the front door, as indicated in the previous article.
We replace hoses and tubes if damage is found, and we also replace hoses after 150 thousand kilometers or five years of vehicle operation
The car has four brake hoses
- How to replace the crankshaft cuffs of the Mazda 6 engine
- Design feature of the Mazda 6 manual transmission
- How to remove the steering knuckle of the front suspension of a Mazda 6 car
- Removing the coils and spark plugs of a Mazda 6 car
- Removing and installing the flywheel of the Mazda 6 engine
- Feature of the clutch design of the Mazda 6 car
- How to replace the lower lever and the stretch of the Mazda 6 front suspension
- Checking and replacing the Mazda 6 vacuum brake booster
- Replacement of fuses and relays of the Mazda 6 car
- Removal of the decorative casing and mudguard of the Mazda 6 car engine
- Replacement of shock absorber and rear suspension springs Mazda 6
- Replacement of Mazda 6 car lighting and alarm lamps
- Removing the selector and transmission control cables Mazda 6
- Design features of the Mazda 6 brakes
- Removing the handles and locks of the front door of a Mazda 6 car