The engine cooling system is liquid, closed type, with forced circulation of the liquid.
The system consists of a cooling jacket in the cylinder block and cylinder head, a radiator with an electric fan, a heater radiator, an expansion tank, a water pump, a thermostat and hoses
We remove the chain when overhauling the engine and when replacing parts of the gas distribution mechanism
Electronic control unit installed under the floor tunnel lining
The ECU has built-in micromechanical sensors that measure the longitudinal and lateral acceleration of the car in a collision
We remove the hood for replacement or for repair, and also remove the hood when removing the engine and power plant components
Remove the gearbox for replacement or repair
Faults that require gearbox repair:
We remove the supports of the power plant during repair, as well as for replacement
The power plant is attached using three supports, two supports on the right and left and one on the bottom
Generator repair consists of disassembling and replacing defective parts. In this generator, you can replace bearings, solder brushes, replace the voltage regulator unit and other parts
