The vehicle's electrical equipment is protected by fuses and relays. Some of the fuses are located in the passenger compartment

  1. Checking and replacing the engine coolant Renault Duster
  2. Fuses and relay Renault Sandero
  3. Installing the cylinder head of the K4M engine
  4. Removing the ECU and sensors COURT car Renault Duster
  5. Checking and replacing the accessory drive belt Renault Sandero

In the article, we will look at how to bleed the refrigerant from the system, replace the tube seal rings and parts, and replace the cabin air filter element

During operation, the ignition switch is subjected to high mechanical and electrical loads, which is why the contact or mechanical part of the lock fails.

Mechanical three-shaft gearboxes of three types are installed on UAZ vehicles: - four-speed, with synchronizers only in III and IV gears;

We remove the lower arm and the extension of the lower arm of the front suspension for replacement

Removing the anti-roll bar for repair and replacement

We install the cylinder head after repair, inspection and fault detection. Before installing the cylinder head, set the cylinder pistons to the middle of the stroke.

We replace the valve stem seals when repairing the cylinder head, as well as when the caps are worn.

Remove the bumper for repair or replacement The work is best done on a lift or a viewing ditch

Preparing the car for the task. Disconnecting the negative battery terminal