Nissan Almera
We remove the facings when dismantling the instrument panel, removing the parking brake lever
The reason for the decrease in oil pressure may be a malfunction of the oil pump
The front suspension is independent, MacPherson type, with triangular wishbones and anti-roll bar.
We remove the instrument panel when repairing the interior heater, when replacing the wiring harness and performing some body work.
We replace the belt after 60 thousand kilometers of the car or four years of the calendar life.
We remove the wiper mechanism to replace the gear motor and the wiper trapezoid.
Wheel drives with equal angular velocity joints are used to transmit torque from the main gear to the drive wheels at different wheel angles and suspension travels
We replace the crankshaft seals in case of oil leakage
We remove the pan for repair or replacement, as well as to replace the gasket if there is oil leakage through the gasket, if tightening the bolts fails to eliminate the leak
We remove the power steering pump when dismantling the engine or to replace it
Remove the radiator for cleaning, checking and replacing
We install the car on a lift or a viewing ditch
Clutch with manual transmission - dry, single plate, diaphragm
We replace the clutch cable in case the cable is “loose” or breaks
We usually remove the shock strut if the parts of the shock strut are out of order:
- - upper support bearing wear;
Evaporator is removable for replacement in case of failure
The outer tip of the steering rod is replaced if play of the ball joint of the rod is detected or the ball joint cover is damaged
On-board DC vehicle network with a nominal voltage of 12 V
