Nissan Almera
From below and from the sides, the power unit of the car is closed with special shields
We replace the pump in case of noise from its bearing or in case of tight rotation of the pump pulley, large radial play of the pump shaft
We remove the bumpers to access other parts and assemblies of the car, as well as when replacing or repairing bumpers.
One of the reasons for the absence or incomplete charging of the battery is a partial or complete failure of the generator.
In this case, you have to remove the generator and check and repair.
The receiver must be removed when removing the cylinder head cover, when replacing gaskets in the receiver connections.
We remove the camshafts for replacement as well as for the repair of cylinder head elements.
The thickness of the brake disc must be at least 19.8 mm.
If there are cracks, deep scratches, ripples, or other damage on the brake disc, it must be replaced.
The need to remove the steering column occurs due to a malfunction of the column shaft bearings or intermediate shaft universal joints
The outer tip of the steering rod is replaced if play of the ball joint of the rod is detected or the ball joint cover is damaged
The wheel (working) cylinder of the rear wheel brake mechanism is replaced when the braking efficiency of the wheel decreases due to jamming of the pistons in the cylinder or leakage of brake fluid through the cylinder seals
Clutch with manual transmission - dry, single plate, diaphragm
