engines
The engine of a car is the engine that drives a car.
All operations are conditionally shown on the removed engine.
Because the engine can be installed on different types of cars.
The air supply system of engines with a selective catalytic converter system consists of the following components:
We replace the crankshaft seals if there is a strong oil leak.
Before replacing oil seals, make sure that oil leakage is not caused by increased pressure in the engine crankcase due to a clogged recirculation system.
The K4M engine is gasoline, four-stroke, four-cylinder, in-line, sixteen-valve, with two overhead camshafts.
The order of operation of the cylinders: 1-3-4-2, counting - from the flywheel.
In the previous article, we covered the removal and installation of the engine cylinder head.
This article will describe how to check and repair the cylinder head of an ISF3.8 engine.
A worn/poorly installed belt and tensioner or a misaligned pulley can cause the belt to come off
Check the tension and condition of the accessory drive belt at every maintenance.
The belt should be free from engine oil, scuffs, fraying, cracks and indentations.
Preparing the car for work. Disconnect the negative battery terminal.
Removing the transmission
In the article, we will consider checking and replacing parts and assemblies of the oil system of the Cummins ISF3.8 engine
The diesel electronic control system allows to reduce fuel consumption and emissions of toxic components with exhaust gases (EG), improve the quality of regulation (accuracy, smoothness and speed) and the stability of the idle speed, reduce the rigidity of the diesel engine working process.
We remove the crankshaft and install it during the overhaul of the engine.
We check and adjust the valve clearances when repairing the cylinder head, when a loud knock appears in the upper part of the engine.
The instrument cluster is equipped with an audible signal to additionally inform the driver about critical and emergency modes of operation of the main vehicle systems.
Rotate the crankshaft so that the pistons are below the carbon deposit zone above the piston ring travel zone.
In the article, we will consider the removal, inspection and installation of elements of the engine fuel system.
We remove the cylinder head to replace the gasket under the block head, as well as for repair.
