The vehicle's electrical equipment is protected by fuses and relays. Some of the fuses are located in the passenger compartment

  1. Checking and replacing the engine coolant Renault Duster
  2. Fuses and relay Renault Sandero
  3. Installing the cylinder head of the K4M engine
  4. Removing the ECU and sensors COURT car Renault Duster
  5. Checking and replacing the accessory drive belt Renault Sandero

Replacing the Kia Magentis rear suspension arms Remove the rear suspension parts for replacement and repair

We replace the gasket under the cylinder head when repairing the engine or if there is a passage of gases or cooling liquid through the gasket

The ignition system is non-contact. It consists of a distribution sensor, a switch, an ignition coil, spark plugs, additional resistance, an emergency vibrator, high and low voltage wires

We remove the upper arm of the front suspension to replace silent blocks or to replace the entire arm when the ball joint is worn and the arm itself is deformed

We replace the working fluid in the hydraulic drive of the brake system in accordance with the maintenance schedule - every 30 thousand kilometers or after two years (whichever comes first).

To prevent damage to the paintwork of the body wings, it is necessary to use a special coating

Removing the head from the engine was discussed in the article - " Dismantling the cylinder head » Disassembling the cylinder head in the article - " Disassembling the cylinder head " In this...

The car uses a speed control system to help the driver not exceed the set speed of the car

Fenders and mud flaps serve to protect the car body from damage To remove the front wheel liner, remove the wheel from the side of the work being performed