engines

We check and repair the unit during the overhaul of the engine.

The engine must be thoroughly washed and cleaned after removal from the vehicle.

We install the engine on a stand or stand.

We conditionally remove the cylinder head from the engine dismantled from the car. Therefore, operations to prepare for the removal of the cylinder head are not considered in this article.

We install the cylinder head after repair, inspection and fault detection.

Before installing the cylinder head, set the cylinder pistons to the middle of the stroke.

The efficiency of starting and running the engine largely depends on the quality and correct fuel injection.

Before assembly, it is necessary to design the cylinder block and determine its further operation

After we have prepared the nodes and the parts for assembling the cylinder block, we proceed to the assembly.

The assembly of a connecting rod with a piston is discussed in the article - "Piston assembly" .

After removing the engine from the car, install it on the stand.

To check the elements of the engine starting system, you will need a digital tester and connecting wires.

Removal and disassembly of the engine cylinder head is discussed in the relevant articles.

After dismantling the cylinder head, you need to wash all the parts of the head, clean them from carbon deposits.

Preparing details for inspection.

Cummins ISF3.8 diesel four-stroke, four-cylinder, in-line, sixteen-valve, liquid-cooled, turbocharged engine

The engine is dismantled for overhaul. Conditionally, the engine has already been removed from the car.

Motor mounts removed and engine mounted on a frame or stand

In the intake manifold of the ISF3.8 engine, the installation of an intake air heater for a start-up aid system is provided

Remove

Remove the accessory drive belt.

Remove the crankshaft pulley.

VAZ-2123 gasoline four-stroke, four-cylinder, eight-valve, in-line engine with an overhead camshaft